Recheck the speaker cable and the output terminal of the speaker.Ĭheck if the antenna under normal conditions. Cable input / output cable is connected properly On some conditions for the selection of the source to adjust the tuning source, without any bass compensation.īalance or control sound settings are set on one side, fader and balance settings at the center position. If it still does not work, unplug the power and plug it in again after a while. A memory connected to the power lines and the positive power supply. ACC position Auto Ignition System: hints same cable connected to the battery. Remove first the bad and replace it with a fuse that has the same size that is new to the block output.īox Fuse: make sure there’s no short-circuiting between the wires replace the old fuse with appropriate capacity. Do not combine with the power cord, as this may cause damage to the machine. Note : Do not use the speakers connected to ground or a body or touched one another. Disconnect power to the connected speakers to avoid shorting. – Red (power cord) : 12v power switch and connected (with the lines on the vehicle ignition switch controls) Speaker cable connection: this tool is design to use speakers with impedance of 4 – 8 Ohm. Yellow (cable memory) : a positive connection with the 12v constant voltage (supplied with the machine memory lane)

Check to avoid shorting, that everything is connected and then connect the negative pole of the battery.

Power and polarity: positive line and positive pole of the battery and ground the negative (negative pole at the end)

Installation of metal connection: consider an illustration, a set of metal into the instrument panel.

Please pay attention when installing the wiring diagram The incoming/outgoing number will be displayed and read aloud by the unit. The unit however does not support a phone book function.

This unit supports Bluetooth calling and Music playback from your phone.

The unit wil I display MP3/WMA which is being played currently. Do not open a picture or video on this unit.

The unit can play MP3/WMA music format.

Before installation, please pay attention to the wiring diagram and connectivity.

Do not place metal objects (screws, coins) and other components into unit.

When playing from USB, please be careful not to enter a damaged file, to prevent damage from the machine.Unplug USO/SD card ifit’snot used for a longtime.

lf the machine does not have a supply power, Please check the connection status and see whether everything is normal.

lf your vehicle is exposed to direct sunlight which causes excessive heat in the vehicle, then you shou Id wait for lower temperature to operate this head unit.

Please read through these operation manual so you will know how to operate your model properly.

Dongle cord